Decal Installation Instructions

1 - Prep Your Surface and Pre-Squeegee Your INVSBL Decal

Prepping the Area - When necessary, clean the surface of your item before applying the Decal using either soap & water, all purpose cleaner, or a mixture of rubbing alcohol and water (50/50 mix).

Pre-Squeegee - Before applying, place your decal face down with the white ink side facing up. Using the end of a squeegee, run over the whole design with pressure, back and forth 2-4 times to push the Decal onto the top carrier sheet.

2 - Preparing your Decal for Transfer

Gently peel the two sheets apart, watching to ensure the whole design lifts off onto the top carrier sheet. Peel slow; use your eyes. If parts don't lift, re-squeegee from behind, and attempt to peel again from a different angle.

3 - Placing your Decal onto Your Window

First, identify the placement area.
For small decals, carefully place the design onto the placement area with two hands controlling the placement.
For large decals, it may be easier to place the decal starting from one side and ending at the other. This will help control your placement, reduce bubbles underneath the design, and avoid wrinkling of the top carrier sheet which could cause design elements to be offset and/or design overlapping.

4 - Completing the Transfert Process

After placing the design, firmly press with your fingers or squeegee it 2-4 times. Peel slowly, watching to ensure all elements stick. If any part of the design is not adhering, lay the top carrier sheet back down, re-squeegee and try peeling from a different angle.